Stainless steel water tank chassis 1, first floor according to the design requirements placed on anti-chassis, after checking the correct position, assembled and measured diagonally tolerance (L × 1.5mm), solid point. 2, the cross joint and outer edges, respectively, of each spot-weld joints after alignment. 3, the central part of the slab every 50mm weld a solid point. 4, all four sides of the weld seam, and then welded cruciform joints, seams from outside the distribution center position welding, to prevent uneven deformation in the same direction once weld length should not exceed 300mm, after changing the direction of security in the same way the corresponding welding, until fully seam welded, strict operation to prevent deformation. 5, will be erected floor kerosene leak check. 6, the plate is placed on the front of the chassis, backplane peripheral T-joints and floor standing seam in phase at the casting, welding seams into approximately 50mm. Stainless steel water tank recommended: Yunnan stainless steel water tank: www.jiechangyn.com Henan stainless steel water tank: www.jiechanghn.com Guangdong stainless steel water tank: www.jiechanggd.com Guangxi stainless steel water tank: www.jiechanggx.com Jilin stainless steel tanks: www.jiechangjl. com Zhejiang stainless steel water tank: www.jiechangzj.com Shanghai stainless steel tanks: www.jiechangsh.com have jokes network: www.uxiaohua.cn Inspirational Network: www.lizhi168.cn